Re: ESS not moving my axis
What driver is your bob connected to?
Re: ESS not moving my axis
Re: ESS not moving my axis
I think you need to use a multimeter and see where you are losing the signals. Check:
- Status of pins on diagnostics screen.
- Status of pin on the ESS.
- Status of pin on the terminals of the board.
- Status of pin on the terminals of drive.
- Status of LEDs for the pins in the breakout board.
The step pin may be difficult to measure, but the direction pin is easy as it should change from 0 to 5vdc every time you change the commanded direction for the motor.
If the problem continues, please feel free to open a support ticket in our website and we will give you a hand troubleshooting this:
https://cnc4pc.com/contact/
Arturo Duncan
https://cnc4pc.com