1 Attachment(s)
V Carve Pro unwanted ramps on slots
Hi
Im having trouble cutting slots in V Carve pro.
When I cut a simple L shaped slot, it plunges ok, but when it gets to the end, instead of leaving the slot squarely upwards, it ramps on exit
I'm using the 'Profile Toolpath' option to cut the slot with a 6mm mill bit. I can see no option to adjust this.
How do I get it to leave the cut slot with out ramping up?
Re: V Carve Pro unwanted ramps on slots
Is the ramp actually in the g-code, or is your controller causing the ramp?
Re: V Carve Pro unwanted ramps on slots
Quote:
Originally Posted by
ger21
Is the ramp actually in the g-code, or is your controller causing the ramp?
I'm not sure. From the 3D preview it looks like its cutting normal. There doesn't seem to be an option in v-carve tool path options for anything which would cause it as its all greyed out as the slot is a simple procedure.
In 'Toolpath Options', is 'Profile toolpath' (the 1st option) the correct one to use for this type of cut?
Re: V Carve Pro unwanted ramps on slots
My guess is that your controller is doing it. What are you controlling the machine with?
1 Attachment(s)
Re: V Carve Pro unwanted ramps on slots
Quote:
Originally Posted by
ger21
My guess is that your controller is doing it. What are you controlling the machine with?
I have MACH3 running on laptop, I'm not sure what the controller box is called. Everything else is running fine. It cuts voids, shapes spot on. But on a one way a - b slot, it ramps as it leaves the slot. (not stop and go upwards motion).
Re: V Carve Pro unwanted ramps on slots
What is your Z axis acceleration set to in Mach3? Increasing it will probably fix the issue.
2 Attachment(s)
Re: V Carve Pro unwanted ramps on slots
Quote:
Originally Posted by
ger21
What is your Z axis acceleration set to in Mach3? Increasing it will probably fix the issue.
Here are the Z Axis settings and final G-Code:
Re: V Carve Pro unwanted ramps on slots
Go into Config >General Config, and check the box "Stop CV on angles>" and set it to 89.
Re: V Carve Pro unwanted ramps on slots
Quote:
Originally Posted by
ger21
Go into Config >General Config, and check the box "Stop CV on angles>" and set it to 89.
Thanks. I'll give that a try tomorrow. Does the info I provided suggest that will work?
Re: V Carve Pro unwanted ramps on slots
Quote:
Originally Posted by
ger21
Go into Config >General Config, and check the box "Stop CV on angles>" and set it to 89.
Thank you very much.
Problem sorted! :)