2 Attachment(s)
Trumpf Laser, Problem DIAS3
Hello,
I need the help to resolve thee problem at Trumpf laser TCL 4030
I have error :
1) PLC (70.100007): DIAS3 (1) negative lag distance exceeded
2) PLC (80.100102): Hight regulation error
Can you send me your experience to resolve the poroblem .
Thanks.
https://www.cnczone.com/forums/attac...d=389256&stc=1https://www.cnczone.com/forums/attac...d=389258&stc=1
Re: Trumpf Laser, Problem DIAS3
hello,
can someone tell me what does the two digits on the DIAS 3 module means?
i have 18 most of the time and when i try to move the Z axe to the cutting height, the head moves in the opposite direction, up to the mechanical limit and 33 is blinking.
the coaxial cable is new. there is no shortcut in the head sensor.
in the machine parameters i have DIAS 3 set properly but when i start a program, i get the message.....Error 60 DIAS IS NOT PROPERLY APPLIED.
Any hint will be highly apreciated.
Re: Trumpf Laser, Problem DIAS3
Здравейте
На ДИАСА ми светна код 7
Дали знаете какво означава
Машината е trumpf 3030
Благодаря предварително
Re: Trumpf Laser, Problem DIAS3
This post helped me, thank you! I have a Trumpf 3040 and had codes for DIAS3 and height regulation. I checked the bolt on the back of the z axis and it had backed out by about 1/4". Tightened it back up and we were up and running. Thank you, I wouldn't have looked there!
Re: Trumpf Laser, Problem DIAS3
Hello,
I have problem with the software of dias, please do you have V4.2 dias software to install this dias software to my dias using a boot disc and cable. Best regards.
Thank you.
My WhatsApp +21627452571