Re: wiring spindle to mx4660
Hi Jacques, I replied your email before, as below...
I checked your spindle DDBLDV 1.0 manual that it can be controlled by external analog input as motor speed control.
However, its voltage 5V outputs is a little low for mx4660 "+10vdc in" but you can have a try .
DDBLDV 1.0 side MX4660 side
"5V " connected to " +10vdc in"
"VE" connected to "0-10v out"
"GND" connected to "EGND"
The pin14 (PWM)/pin25(GND) of DB25 on mx4660 is used for receiving PWM signal to control analog signal (voltage) output to your DDBLDV 1.0 for motor speed control.
Refer to page 10, [COLOR=inherit !important]http://www.leadshine.com/UploadFile/...4660d_V1.2.pdf , pins instructions.[/COLOR]