How to set contour overlap on Haas machine?
Machine is older, it is actually Mikron Haas VCE 500, but the control is very similar/equal to newer Haas mills.
We have problem with this machine that it doesnt finish contour (toolpath) very precise, for example if you make a circle it will leave a small amount of material around start/end point of mill toolpath (circle).
So we deal with this in CAM software, to extend this toolpath for example by 2mm... or make 2 circles instead of one.
But this problem occurs only on this older Haas machine, we have 2 newer and they dont have this problem.
Is there a parameter or setting on the machine which could overlap this contour for some amount so this problem wouldnt occur?
Thanks in advance.
Re: How to set contour overlap on Haas machine?
I am very happy to find this information. Thanks for sharing this knowledge with us. https://www.wiretree.ca/
Re: How to set contour overlap on Haas machine?
It would seem to me that setting a proper leadin/leadout in the CAM setup would solve this problem.
Re: How to set contour overlap on Haas machine?
...try using G61 Exact Stop code or use G09
Re: How to set contour overlap on Haas machine?
That is not the solution its a patch. I want to fix machine not change gcode
Re: How to set contour overlap on Haas machine?
Quote:
Originally Posted by
allenp
That is not the solution its a patch. I want to fix machine not change gcode
I guess the fix might be to call Haas and get a software/hardware upgrade to match the newer machines. Or at least see if they can suggest a parameter change that would fix that.
Re: How to set contour overlap on Haas machine?
I am very happy to find this information. Thanks for sharing this knowledge with us Visit: https://thesimpleindian.com/