Re: R8 NT30 spindle runout
I will measure mine today as I have been wanting to for a while now. I also have some stuff I need to cut so I will report back with my run out numbers .. I have though about switching it back to a R8 but like the fact I can hog stuff off with the stronger holder
Re: R8 NT30 spindle runout
OK I made a video ( have not posted it ) but I checked my spindle with a holder in it with a 4 flute carbide BN 3/8" diameter and I came up with .0005" out I think that is plenty good and was quite surprised to tell you the truth. now that was moving it by hand I am curious to know what it has for run out with the clattery spindle going .
Re: R8 NT30 spindle runout
Do you have the stock bearings in your spindle? What brand of NT30 holder do you have? Check a few of yours please. I have one that's .0005" and others that vary from .003 to .005!
2 Attachment(s)
Re: R8 NT30 spindle runout
3 8" NMTB 30 End Mill Tool Holder 1 2 13 NMTB30 Ground | eBay
I have a few of the tax and they seem to be pretty nice. I only have 1 of the 3/8 but I ordered another and it should B here any day and will check it with the same cutter. As far as bearing they are not the original I would have to go through the original owners post to find out what kind they are if he posted them .