Mitsubishi Mill Meldas 300 series control

I started working at a new shop about three months ago. Since I got there this mill hasn't run. First the control was in Japanese after we moved. Then the table would not go operate properly after it was homed. After another round of repairs it is up and running. I am not sure how the canned cycles or the tool changer work. I tried to bore out a burned out hole with a canned cycle to no avail, i could not figure it out. I programmed the circular interpolation line by line by hand and changed tools manually. Is there anybody or anywhere with some sample programs I could see and teach myself what is going on. Thanks

what about reloading canned cycles from eprom after initialization?
PLC I/F -> (1001)()(M) -> parameters -> base -> Fix_P = 1 -> data in/out -> input -> #(4) () -> "input" pushbutton -> PLC I/F -> (1001)()(U)

hi I work with the same machine if you post your code I can help you straighten it out. and teach you how to change tools