60W chineses laser cutter main switch

Good afternoon, we are a small company in Laredo, Tx and we have a 60W chinese Laser cutter that we use for engraving in Tumblers, cutting boards, acrylic and wood. Last week after 4 years it did not turn on and what I was told by an electrician it might be the main switch. We have been looking for it but with no luck my question is do you know where I can find this switch. Another thing the electrician told us is that if it's not the switch he would need the electrical diagram and if we can't find a part the diagram is impossible. Hope you can help us.

Thank you
Alfredo Salazar

In the third pic there is a fuse in the side that the power cord plugs into.

Yes, like fixtureman1 suggested, take a small flat head screwdriver and pry out the fuse where you plug in the power cord, assuming of course that you haven't already tried that, I learned about that just last night when my chiller quit working after about 5 minutes, I never knew it was there.

Good luck.

Quote:

---

Originally Posted by fixtureman1

In the third pic there is a fuse in the side that the power cord plugs into.

---

Sorry for the delay in answering. Yes, I did and so I been looking for a 15 amp fuse at is 2mm long and can't find it.

- - - Updated - - -

Sorry for the delay in answering. Yes, I did and so I been looking for a 15 amp fuse at is 2mm long and can't find it.

It is 20mm long by 5mm diameter.
Manufactured up to 16A.