Need Help! Fanuc Alarm 1400, 607, 613, 9004

Machine: 2008 Sharp SV-2412
Control: Fanuc Oi Mate-MC

Alarms: 1400 SPINDLE ALARM
607 X AXIS:CNV. SINGLE PHASE FAILURE
613 X AXIS:CNV. SINGLE PHASE FAILURE
607 Y AXIS:CNV. SINGLE PHASE FAILURE
613 Y AXIS:CNV. SINGLE PHASE FAILURE
607 Z AXIS:CNV. SINGLE PHASE FAILURE
613 Z AXIS:CNV. SINGLE PHASE FAILURE
9004 SPN 1 :INPUT FUSE/POWER FAULT

I boot up normally, get the 607 and 613 codes, then after maybe 20 seconds a breaker trips and I get the 9004 code. The servo drive has a normal status until the 9004 code trips, then the LED on the servo drive gives ALARM 04.

Any thoughts on how to diagnose this? I was making chips last night, nothing out of the ordinary. I power up this morning and this is what I get.
Thanks for any advice,
Max

Here's a video of what happens after I click off the E-Stop. As soon as I turn off E-Stop, the control tries to send power to servos etc and then I get alarms 1400, 607, 613. After about 20-30 seconds the breaker/switch pops and I get Alarm 9004. The popping switch scared me a little bit lol
https://www.youtube.com/watch?v=tMI6sbZCBKI


Here's a video of the servo unit. Is the sound coming from the box normal? It's made that sound since I purchased it a couple months ago.
https://www.youtube.com/watch?v=tuMQ01gzoBc

This is a common issue within the power supply section of that unit. If you would like to give us (Tri Star CNC Services) a call at 815-578-9145 we can discuss it further.

https://www.tristarcnc.com

We offer free phone support to help you troubleshoot

815-578-9145

Quote:

---

Originally Posted by MaxWeber

Here's a video of what happens after I click off the E-Stop. As soon as I turn off E-Stop, the control tries to send power to servos etc and then I get alarms 1400, 607, 613. After about 20-30 seconds the breaker/switch pops and I get Alarm 9004. The popping switch scared me a little bit lol
https://www.youtube.com/watch?v=tMI6sbZCBKI


Here's a video of the servo unit. Is the sound coming from the box normal? It's made that sound since I purchased it a couple months ago.
https://www.youtube.com/watch?v=tuMQ01gzoBc

---

Hello sir ,I'm also facing the same issue please help me with a video clip

Im having the same issue to with the same alarms. How can i fix this.

Quote:

---

Originally Posted by Noelantonio

Im having the same issue to with the same alarms. How can i fix this.

---

It ended up being a bad power supply board that had to be reworked. TriStar CNC performed the repair. Some bad resistors on the dc circuit close to the lugs.

Im having the same issue to with the same alarms. How can i fix this.

Ok so,
Is that board is removable and can be fix by them or just need a new one?

Also , what do you mean by the Lugs?

Thanks