I'm missing something somewhere...debugging and sound?
My Google-fu is either lacking, or I'm missing something somewhere. I need help finding 2 things:
a) how do I turn debug mode on? In other words, rather than using (print, blah blah)...I want to use (debug, blah blah)...
b) how do I get it to beep / siren / any noise at all when it's done?
Many thanks in advance; I'm just losing hair here, there are references but no examples I can find in the documentation.
Lee
Re: I'm missing something somewhere...debugging and sound?
Perhaps this page will help:
https://planet-cnc.com/category/software/
In the Troubleshooting section is this debug example:
Quote:
Troubleshooting
If inverter will not respond to any spindle gcode command , it indicates that something is not ok.
Type into the MDI window the following text:
=debug = 1
Test the M3, M4 and M5 codes again.
Observe the output window and the printed text.
Re: I'm missing something somewhere...debugging and sound?
I saw that. It doesn't seem to do anything and that applies to a specific piece of equipment, I think.
I have a series of (print, blah blah) commands and I only wanted to show them if the debug was on; I changed one to (debug, blah blah) and now it simply doesn't show that line. I'd prefer not to have a bunch of
O23 if [#<deeebug> EQ 1] (print, blah blah) O23 endif
type statements (I'm not sure exactly what it would look like, but it would certainly be clunky.)
Seems like a bad approach to the problem, so I'm figuring debug is the way to do this.