-
Dear Mazatrol-knowers,
I`m working at a MAZAK H630 with M32-Controller. There I´ve the following problem:
After running a program in Tape-modus, the program is sended with Mazak-Camware in DNC-manner, the controller doesn`t run without switching off before doing the next job. What could be the reason for this?
-
Maybe you send to controller also all parameters previously transferd with program from NC to PC. So before program transfer from PC check which data you will tranfer to NC? So before pressing "START" on data transfer display on NC check the values under parameters, tool data, tool offset.... if do not have value 1? ;)