sprutcam 9 tool library issue, waterline issue, was working fine

when i go to library to select a tool, seems to be defaulting on tool 2, when i pick another tool it cell N stays stuck at tool 2 if its a new operation or whatever tool it was already set to if its an existing operation. i have to manually change the tool number in cell N.

i also noticed i can no longer sort the rows by tool number by picking the top column header.

my rough water isnt working at all AND my finish waterline isnt working like its suppose to. it was all just working fine 5 minutes ago.

any ideas?

thanks

Carlos
TPR Motorsports

nevermind, i must have somehow fat fingered the use tool number box, i checked it and the sorting and tool number issue is fixed.

my waterline isues is from the model, somehow the surface is not flat.

Carlos
TPR Motorsports