1 Attachment(s)
Bridgeport R2E4 Boss 10 Series II Parts
I retrofitted my mill to Linux and I have all the old parts leftover from the original machine. There was a problem with the driver boards which would cause an intermittent fault, I'm not sure what the issue was since I never tried to diagnose it. Other than that the machine ran fine, and had very low hours. I'm not posting prices because I don't want much for any of it, I'd rather not give the parts away, but I'd also rather not throw them away.
https://www.cnczone.com/forums/attac...d=425854&stc=1
The screen and control board was replaced by the previous owner and only has a few hours of use on it. I have the stock encoders as well.