-
Interact308 problems
Hey guys I'm wondering if anyone here can help me. I have a 1990 Bridgeport Interact 308 VMC that im having some issues with. the first issue i had was the 24Vdc powersupply went bad. Ive fixed this problem but now the spindle will not orient itself for tool changes. when i run a tool change program the Z axis goes to the right height and then the spindle oscilattes back and forth.
this machine uses a Heidenhain tnc 2500 controller. any help here would be much appreciated
Patrick Polinder
-
I know that the DX controled 308s had a KTK spindle drive. What does this one have?
Is the spindle speed accurate?
George
-
This one has a ControlTechniques Flux Vector Drive type V400.
I'm no sure how accurate the rpm are. I can check the rpms at a low speed
tomorrow and check them against the tachometer on the screen
Patrick Polinder
-
Control Techniques did make the KTK drive but I am unfamiliar with the V400 designation. I will do some research when I get a chance to get by the office.
I questioned if the RPM was even close to see if there was a speed feedback issue.
George
-
I actually worked on an interact 308 today. Had to resurrect the parameters. The ETS is wrong in a few places. But with a list of parameter definitions, I managed to get it going.
Is there a way to get a copy of your parameters?
Could you fax it to 1-205-403-8900?
Or email them to me.
I see what you mean about the FLUX VECTOR DRIVE and the orient board just to the right. Bosch drives. And a very unusual place for the control.
George
-
Can you send a copy of the V400 and TNC 2500 parameters ?
-
machentek
could you please help me with a list of the parameter meanings for the v400 flux vector drive.I need to replace a drive on a BP 308 and will use a unidrive.
Thanks in advance
Bertie
-
1 Attachment(s)
Here you GO...
Sorry dont have a description of the parameters.
-
Thanks sgarciam, Much appreciated.
Bertie
-
1 Attachment(s)
-
Excellent Thanks Sgarciam buy the way beware of the two metalised paper capicators on the power board of these drives.They can burn and destroy the board plus the 3 phase bridge and more. Worthwhile changing them
Bertie
-
Re: Interact308 problems
Hi, Any chance you can re send the v400 parameters again as the excel attachment won't open. Regards bob
-
Re: Interact308 problems
I'll have to see where they are at