Printable View
Hi folks, we are a company specializing in CNC electronic repairs.
Call us for Hitachi Seiki repairs:
1) Servo & spindle motors
2) Power supplies
3) Monitors & touch screens
4) Servo packs & drive units
5) Control boards, and motherboards
Free evaluation on Hitachi Seiki Repairs.
>> Yaskawa Hi-Cup servos rebuilt with new custom retrofit encoder!
Please visit us at www.controlsandgadgets.com/hitachi-seiki.htm
Regards,
Phil Cerrito
Fast service & great prices!
Hitachi Seiki Continued...
We rebuild the Hitachi Seiki Hi-Cup motors. All rebuilds include a new retrofit encoder too!
Price: $2,295.00
Hitachi Seiki Repairs
PS- We are looking to partner with someone who is knowledgeable about these cnc machines.
See Picture In Previous Post...
hI
My name is Michal I'm from Poland.
I have a Hitachi Seiki HT20R. The problem is with the main motor yaskawa drive. There are no errors after the machine is started and referenced. When I try to set RPM in YOG mode, the load meter goes to 110% on the Yaskawa panel, the RUN indicator lights up but the engine is stopped. Can you somehow help ??
Best regards Michał
Hello Michal
What is the control - i80 Yasnac? When trying to to jog the spindle manually in jog mode, you say the load meter goes to 110% but is not actually spinning?
Can you move the spindle by hand easily? If the run light is on, the NC has given the command to operate but its not getting feedback from the drive for speed attained, so it sounds like a bad connection, but check the drive for errors. Usually a spindle drive error would show on the NC side. let me know for sure
john
Hello John
Thank you for your interest in the subject. The control is Seicos L Multi.
The spindle turns slightly.
How can I check the disk for errors? No errors are shown on the machine's desktop.
Please reply.
Regards Michał
Hello,
Please give me an email. I'll post the procedure I went through.
Regards, Michał