-
Hi CNC community
I ask myself again and again: is there no better course material for the 5-axis milling than the few hours long course directly at Hurco?
Since May I have a VMX60SR and I would still like to have some documents to reread some stuff. I don’t like to have one hand on the potentiometer and the other hand on the emergency stop to run a work piece- the mysterious travel paths are occasionally frightening.
So my question are there such help functions or alike or do I always need tojust scrape it together how it should work?
Joseph
-
My training is not until January.
But I think you have confirmed my fears:
That this short time is not sufficient.
I have already read the instructions for the 5-axis milling,
but this mix of German and English is absolutely meaningless without any graphics.
-
That’s the problem because the help on the machine is not very good at all and doesn’t help.
Kind regards
