Printable View
Hello,
We have 3 machines with the old c200 controllers from index: one gs30, one gs42 and one gs65. There’re full alphabet and brackets for comments on the keypad.
So how can I write comments in a program?
For example:
T1212 L999 (stop)
Is there a particular keys combination therefore?
As a skilled programmer I’m used to comments.
Additionally I’m searching for a boring cycle for chip breaking.
I help myself with the deep boring cycle L98 now.
Thanks in advance.
Hello
I also have these controllers. So far I know you can’t write these texts at the machine.
I write my texts in the programming space during compiling.
They are input then and are viewable.
Regards
wimu
It would certainly work at the laptop, but I think the guys from Index have meant something inserting the buttons.
You can use the keys only in the DNC mode, Index C200/T200.
Regards, Runde
Ok, it explains everything.
Thanks Runde01!
Hello to all
I have an INDEX GSC42 S3TT / C200 TT.
But there is a problem. After turning on and activating the hydraulics,
everything is fine.
By selecting NC1 & NC2, the X1 & Z1 & X2 & Z2 & C & Y1 axes are easily
referenced and no error is observed.
When the tool is called to the roller 1, the TURRET unclamps but does not move.
After a few seconds at a very low speed that seems to be drift axis
Spins and does not recognize the tool and continues to spin.
And E8 & R0 & R5 errors are displayed.
Can anyone help and guide me?
Thank you
Hello to all
I have an INDEX GSC42 S3TT / C200 TT.
But there is a problem. After turning on and activating the hydraulics,
everything is fine.
By selecting NC1 & NC2, the X1 & Z1 & X2 & Z2 & C & Y1 axes are easily
referenced and no error is observed.
When the tool is called to the revolver 1, the TURRET unlock but does not move.
After a few seconds at a very low speed that seems to be drift axis
Spins and does not recognize the tool and continues to spin.
In addition, the x-axis and the roller have a servo motor
They are common and the revolver does not have an instrument counting encoder and
has three proximity switches 1S10 =E2.0 (revolver 1 locked) and 1S3 = E0.6 (revolver 1
tooth pulse) and 1S1 =E1.0 ( position 1)
and two The solenoid 3Y15 =A0.0 (revolver 1 lock )and 3Y14 = A0.1 (revolver 1 unlock )
performs the lock and unlock operation ,
And E8 & R0 & R5 errors are displayed.
I have no documentation of this machine.
Can anyone help and guide me?
Thank you