Brother HS-300 Wirecut EDM
Does anyone have a brother hs-300 wirecut or similar model, i have just bought one and am after a bit of advice with the setup and ion settings.
I have never run one before so i am trying to follow the manual on settings but it quite vague, any help would be appreciated.
Re: Brother HS-300 Wirecut EDM
Hello all,
Same machine here, but cannot get electricity to turn on. When ELEC button is pressed, HIGH VOLTAGE light comes on and alarms out. Alarm is FET ERROR.
Thank you on advance.
Re: Brother HS-300 Wirecut EDM
I would appreciate it if someone could give me a copy of the Brother Communications software. It used to come with the machines on a floppy. It has a file called DHINST on it and that is what I need. When run, it sets up the Brother sub folder on your hard drive. Same for HS-100 and HS-300 etc.
Thanks in advance----Mike
Re: Brother HS-300 Wirecut EDM
Re: Brother HS-300 Wirecut EDM
Got the software, thanks SeymourDumore. :cheers:
Mike
Re: Brother HS-300 Wirecut EDM
Quote:
Originally Posted by
Edvard
Hi
I bought a Brother 350 Wire EDM two years ago and it work very good.I had never used a wire edm before.I use Bobwire and it is very easy to use.
Edvard,
Could you tell me what post processor you use with the Bobwire?
Thanks-Mike
Re: Brother HS-300 Wirecut EDM
Does anyone have a Brother HS-300 SERVO CONTROL PCB ASSY for sell?
pmanoj
Re: Brother HS-300 Wirecut EDM
Hi.
This is Rao Umar from Pakistan. I have had a Brother HS-350 machine in non working condition for the last 6 years. There is a wiring problem in the machine. If you have a wiring manualof the machine. Requesting you to send me the diagram so that i can work on the machine.
Thanks in advance