Re: More Stepper Motor Woes
"24v is very high for a stepper, so the poor performance is fully expected."
An old thread but for any newbies or new readers, the above is complete rubbish, I consider 24V to be a low voltage to run a stepper, those on my large CNC run at 76.
Higher voltages are exactly what is required to overcome mediocre performance. Motor power is directly proportional to the supply voltage divided by the square of the inductance of the coils. Power output increases with higher voltage throughout the rev range.
What is more the 24V quoted is the badge voltage on these drives, as per the OPs original post.