Printable View
Hi guys
I have a doosan 2000SY with a Fanuc 18i-TB control, this machine has X Y Z C1 C2 B axis. I asked around afew differant forums an have been told that Featurecam is the best an easiest program to use for this machine.
Will mastercam X4 support this type of 6 axis machine???
Is there a post processor for a 2007 Daewoo puma 2000SY(fanuc 18i-TB)???
Could some of you guys give me your advise on this subject.
Thanks
Mike
Not sure where in Canada you are but you need to get a hold of In-House Solutions (the same outfit that runs the eMastercam website). They have been writing many of the multi-task posts and multi spindle machines for quite some time. In-House Solutions are around a couple places in Ontario and a place in BC I think. If they don't have one, they can write one.
Mastercam will work with the puma. I have the same machine. You can down load a post on emastercam.com its free and works well. Good luck