After 2 month covid shutdown - 21T wont boot - 4 simultaneous screens of garbage

Hi

machines were shutoff for a covid shutdown, for 2 mos, just tried booting up the 21T. Machine was happily shut down as normal, battery was in good shape (just replaced) prior to shutdown.

After "on"... no pumps coming on, no servos coming on. Screen comes up with what looks like 4 "subcreens" (this is a monochrome monitor, so it def doesnt have the resoloution for 4 screens LoL), looks like top left is same as top right is same as bottom left is same as bottom right - but mirrored 4 times - cant make out the words - as if it was low res.

Looked in the back there is no error just two red bars "- -" which I understand to mean "not ready"...

anyone any ideas ?? in a bit of a jam...

THanks

Here is a shot of the screen:

...the virus continues

Try leaving it powered up for a while....reboot

u mean like leave the mains on.. like to warm it up ? then just hit off and then on again on the control ? this is scary was thinking powered up mught be frying ****.. or do u nean turn off mains to reboot.. has this been seen before ?? im stumped

Do you have a control backup? Do you know how to get to the BOOT screen?

check your 24v to the board

I dont think I have a control backup, I have the parameters, but no card. BOOT screen, no not sure. I will check the 24v..

Whereabouts are you as there maybe an engineer local to you on here