Re: HELP HELP WE NEED HELP
I think you mean wiring the drivers to the BOB, not the motors.
You are close. The details you are missing are normally supplied with the drivers and you should look carefully at that documentation. You can find it here: https://www.automationtechnologiesin...oad.php?id=242
Re: HELP HELP WE NEED HELP
Yes
I have this.
Just little scared about doing the wrong thing.
Sent from my iPhone using Tapatalk
Re: HELP HELP WE NEED HELP
Yeah I think your big power supply needs to be ran to your drivers and not through the BOB. I have only wired a setup once but it worked the BOB I used only used 5v but is different than yours for sure. What BOB is that? And what motors are you using?
Re: HELP HELP WE NEED HELP
The BOB is a Chinese one of course.
6 Axis for Mach 3
The motors I believe are bi-polar
Sent from my iPhone using Tapatalk
Re: HELP HELP WE NEED HELP
Those drivers have a built in power supply.
Re: HELP HELP WE NEED HELP
Do you have any documentation on the breakout board? Not sure why you would have two power supplies wired to it? What voltage are those power supplies, and what terminals are they wired to??
Re: HELP HELP WE NEED HELP
Ger21
I’ll have to get back to you.
Everything g us at school and I’ll be back in Tuesday
Thank you for your interest in helping.
Sent from my iPhone using Tapatalk
Re: HELP HELP WE NEED HELP
Have you contacted CNC Router Parts/Avid for tech support help on your CNC Router Parts/Avid machine?
Mark
Re: HELP HELP WE NEED HELP
Never heard of it!
So no.
I’d like to check it out
Thank you
Sent from my iPhone using Tapatalk
Re: HELP HELP WE NEED HELP
Did not even notice those were ac drivers. That break out board is interesting for sure. I found this description for it on amazon and googled it 0 documentation but there is an instructable may be worth looking at as it had a pic I couldnt read on my phone.
Keenso DIY CNC 6 Axis MACH3 USB CNC Motion Controller Card Interface Engraving Machine Interface Breakout Board
Re: HELP HELP WE NEED HELP
Thanks
Another person in this conversation supplied the actual info.
I’m going to print it out and try to follow it.
I do appreciate your help.
Thanks
Sent from my iPhone using Tapatalk