Mach 3 Jog stepping stops working.
No sure the best place to post this, but I have a custom made gantry mill running off Mach 3. When I set the on screen MPG to step mode, the mill sometimes just stops moving.
It appears to work perfectly fine in Continious mode.
Once it stops responding to Step moves, I have to hit RESET to get it back working again.
Where do I start trying to find out why this is happening?
It's a custom built machine which I bought from someone already built. It works fine but this issue makes setting up a pain.
Is this likely to be a Mach 3 issue or a controller issue or a noise/emc issue?
The controller is a UC100
Any tips appreciated!
Re: Mach 3 Jog stepping stops working.
I'll have to have a look at my setup I had before.
I was able to (using keyboard) jog continuous with arrow or page key pressed on it's own and then jog 0.01mm step at a time with arrow/page and ctrl keys pressed at same time.
Never had to open mpg jog tab after figuring that out.
Re: Mach 3 Jog stepping stops working.
Quote:
Originally Posted by
dazp1976
I'll have to have a look at my setup I had before.
I was able to (using keyboard) jog continuous with arrow or page key pressed on it's own and then jog 0.01mm step at a time with arrow/page and ctrl keys pressed at same time.
Never had to open mpg jog tab after figuring that out.
I think this is an issue with the UC100, once it locks up, it wont move with any keyboard or onscreen MPG. In step or continuous modes.
Re: Mach 3 Jog stepping stops working.
Quote:
Originally Posted by
dazp1976
Do you have legitimate uc100 or one of those Chinese copies that are out there?. The fakes can be iffy.
Maybe try reinstalling the plugin.
I've never liked the idea of the UC100. I always saw it as a temporary bodge when parallel was removed from pc's.
I'd save up for a UC400eth myself.
Hi Daz,
Not sure if its a clone or not. It came with the machine...
I can try a re-install of the plugin and see what happens...