OKUMA MX-55 With U10M Control System
Hii Everyone
here i have okuma made VMC MX-55 with U!0M control system.
i have a problem with Rotary table axis called A axis,when we run rotary axis in cycle mode, it rotate 360 degrees. But some times 1 or 2 times out of ten it rotates and return to 358 degrees and stop without any alarm and there is no stop in auto cycle, cycle run continously.
so please help me to figure out problem i will be very thankfull to u all.
Re: OKUMA MX-55 With U10M Control System
Check with your specifications. Maybe there is a limit how many rounds the A axis can rotate before reset. That means the A axis cannot run the same direction continuously.
There is a special chapter for Okuma in the forum. Name "Okuma".