Printable View
Hello everybody,
At the moment, I often have to mill burned holes for example a 324mm and a 180mm big while.
How can I create a program where I can enter the diameter, the depth (in this case 40mm), the cut
4 mm and the tube size of the drill. (would be 310mm/ 170).
With circular pockets the program always starts
in the middle which would take ages in my case.
Control system 432/10
With best regards
Mischah
Hello Mischah,
Basically only over parameter programming.
Have you ever been engaged with it? If no then you should do that.
If you have an idea about the implementation and a few programming samples then show it and we can
build something here together. What would give you a learning effect that you wouldn’t get if we give you the finished solution =)
Quote:
Hello everybody,
At the moment, I often have to mill burned holes for example a 324mm and a 180mm big while.
How can I create a program where I can enter the diameter, the depth (in this case 40mm), the cut
4 mm and the tube size of the drill. (would be 310mm/ 170).
With circular pockets the program always starts
in the middle which would take ages in my case.
Control system 432/10
With best regards
Mischah
Hello just program the contour with 3 G3 sets: circle IN, full circle, circle OUT and it takes only 1 minute.
Regards