Printable View
Does anyone have the procedure to do a full backup to include the ladder for the 21T controller?
I tried doing a backup to the pcmcia card in the controller and electrical cabinet. It did not recognize that there was a card there.
I have been able to back up what I can with the rs232 cable. I just can't seem to figure out how to get the ladder out of it.
Sent from my SM-G955U using Tapatalk
What size is the PCMIA Card ?
It looks like one of these. https://uploads.tapatalk-cdn.com/201...a337f8fca7.jpg
Sent from my SM-G955U using Tapatalk
If I were you and you cant get it backed up take pictures of each page with your cell phone, You would have to go thru it manually and make the necessary changes by hand but at least you would have itQuote:
Originally Posted by cooperjm
I have taken pictures of the various screens that will not punch out. That method will not help with the ladder though.
Sent from my SM-G955U using Tapatalk
I must have misunderstood what you are trying to do with the ladder ? The ladder for a cnc control is to show/explain where certain components are located and or if they are being used at a certain time . What is it that you are trying to do ? reload it into the system after a memory reset?Quote:
Originally Posted by cooperjm
If you need a pmc ladder back up you will need an sram cardQuote:
Originally Posted by Michael82
The memory card your using is a flash card
Whereabouts are you maybe someone on here is local to you
If your doing a memory clear the old file should be ok
So how do you get the controller to back up to the SRam card? https://uploads.tapatalk-cdn.com/201...40e2b72a79.jpg
Sent from my SM-G955U using Tapatalk
You put the SRAM card in the same place as you put the PCMIA card (on the I/O Board )
Then power up holding the two right hand soft keys under the screen