-
fanuc 10m drip feed
I read a lot about it but I can't figure out how to do that.
I have all 0 in 2001 parameters.
Also I dont have G003.4 bit in ladder board . Also no bit in GOO3 when I try to switch in modes.
Is it any way to work in rapid feed?
I have rs232 port and can send to memory but its really small for big programs. I hope u can help me guys
-
Re: fanuc 10m drip feed
Any ideas ?
by it is possible from computer or something?
i tried everything to find that G003.4 but but i can like it istn exist,
is it mean that i cant do nothing ?
I have really low memory, i think because of parameters too, any idea?
-
Re: fanuc 10m drip feed
-
Re: fanuc 10m drip feed
i sow that i need man who can really know what going on.
Does someone know if i can buy tape reader unit and install it to my machine ?
-
Re: fanuc 10m drip feed
G003.4 will have to be added to the ladder. I highly doubt that there is anybody around with the hardware and software to pull this off. If the machine is in great shape you may think about upgrading the controller.
-
Re: fanuc 10m drip feed
Are u thinking about tape reader unit ?
-
Re: fanuc 10m drip feed