MELDAS 64S M01 OPERATION ERROR 0004

I HAVE A CONTROL UNIT MELDAS 64

M01 OPERATION ERROR 0004


I HAVE CHECK:

1. As the interlock function has activated‚ release it before resuming operation.
2. Check the sequence on the machine side.
3. Check for broken wires in the interlock signal line.
Do not see any unusual problems

I HAVE A M5PLCWIN CONECTION WITH NC UNIT MELDAS 64S BUT WHEN RS 232 COMMUNICATION

I DO NOT UNDERSTAND PLEASE SEND INSTRUCTIONS MANUAL M5PLCWIN

MAIL:[email protected]

THANK YOU VERY MUCH

Quote:

---

Originally Posted by CNC Machine OT

I HAVE A CONTROL UNIT MELDAS 64

M01 OPERATION ERROR 0004


I HAVE CHECK:

1. As the interlock function has activated‚ release it before resuming operation.
2. Check the sequence on the machine side.
3. Check for broken wires in the interlock signal line.
Do not see any unusual problems

I HAVE A M5PLCWIN CONECTION WITH NC UNIT MELDAS 64S BUT WHEN RS 232 COMMUNICATION

I DO NOT UNDERSTAND PLEASE SEND INSTRUCTIONS MANUAL M5PLCWIN

MAIL:[email protected]

THANK YOU VERY MUCH

---

have you solved this problem? Have a machine with the same issue

Hello friends,
I have a problem will my moriseiki Tv-400 with MSC802(50MM). I am gettin alarm M01Operation error 0106 4th axis selection during magazine zero setting. I went to adjust mode made M3148 to 1 then made 6440.2 to 1 select c axis but same alarm appears. Can any one help me

Hello!

Did you find a solution?

I have the same problem.

Find the solution! First schould press H (handle)on the screen, than swich the axis selector to c!!!