Re: Settings for Motor Speed
Quote:
Is there a setting in Grbl Panel to limit the speed of the motors?.
No, all motor settings are set in the grbl controller
Quote:
I did change $100 through $122 in the Grbl settings, but when I closed the program all of the values reset back to their defaults.
Grbl settings set (the right way) will remain after a reboot. I am not familiar using grbl panel, but you could use the Arduino Serial Monitor to change the settings.
As an example: Send $110=100 to the grbl controller to limit the X-axis max rate to 100 mm/min.
Read the WiKi for more information https://github.com/gnea/grbl/wiki/Gr...-Configuration
Re: Settings for Motor Speed
I found that in Grbl panel that you HAVE to press the Enter key for the values to be applied. If you do not, then they will still be visible in the textbox until you close or get the GRBL settings again.
This has cost me many hours of frustration!
Re: Settings for Motor Speed
Now you mention it, there are more program's that require to press enter before the change is actually applied.
I am glad things are working now.
Huub