Fanuc 0iMC -9031 Motor lock or V Sig Loss
Dear Sirs
In MDI/Auto mode, only in case of one particular tool, when spindle speed is more than 1500 rpm, we find Load on spindle (L) as seen at the bottom of position screen to be shooting upto 164%(although tool is running on load ie not in touch with job) and hence trips with alarm 9031, we dont have this problem in case of any other tools even at 2000 rpm
We replaced tool with new one
Spindle Motor has timing belt and there is no gear box.
We can not doubt feedback, as no problem in case of any other tools even bigger than this one
With same set of toolings and same job being made since last 5 years
Kindly revert
Re: Fanuc 0iMC -9031 Motor lock or V Sig Loss
9031 spn 1 motor lock alarm on fanuc control cnc mill
Re: Fanuc 0iMC -9031 Motor lock or V Sig Loss
Does the motor have dual winding contactor? It may be one 'range' contacts are bad.
Re: Fanuc 0iMC -9031 Motor lock or V Sig Loss
I would check the pullstud first, if it is different, it may lead to different travel of the collet mechanism
Re: Fanuc 0iMC -9031 Motor lock or V Sig Loss
Quote:
Originally Posted by
M.RISHIKESH
Dear Sirs
In MDI/Auto mode, only in case of one particular tool, when spindle speed is more than 1500 rpm, we find Load on spindle (L) as seen at the bottom of position screen to be shooting upto 164%(although tool is running on load ie not in touch with job) and hence trips with alarm 9031, we dont have this problem in case of any other tools even at 2000 rpm
We replaced tool with new one
Spindle Motor has timing belt and there is no gear box.
We can not doubt feedback, as no problem in case of any other tools even bigger than this one
With same set of toolings and same job being made since last 5 years
Kindly revert
TRY M 40
M 41
or check the motor