Need Help Setting Up Sherline CNC Lathe!
I'm a total newbie to machining. I got this machine to make some small parts. It's a Sherline 4000 Lathe with a stepper motor installed in a cabinet with a RS232 25 pin out. I have an older laptop that I'm planning on using for the software.
My big question is, is there free CAM software that I can use for experimenting and learning with the machine before I spend any money?
Also, where is there a good resource (book, videos, etc) where I can learn a little bit more about basic machine setup/how to make certain kinds of cuts/internal threading/etc? Any help would be much appreciated!
Edit: Here are some pics.
http://farm8.staticflickr.com/7252/7...0867a314_o.jpg
Sherline CNC Lathe by bedheadben, on Flickr
http://farm9.staticflickr.com/8010/7...ca612d81_o.jpg
Sherline CNC Lathe by bedheadben, on Flickr
http://farm9.staticflickr.com/8006/7...019c070c_o.jpg
Sherline CNC Lathe by bedheadben, on Flickr