Gildemeister CTX400 Eltro Pilot Keypad

Hello all,

I recently installed an EPL 2.2 control unit repaired and refurbished by DMG Mori into a CTX 400 lathe. I have a good boot up with all parameters initialised.
When prompted to press operating mode key I have no response from the keypad. I believe i have a good connection back to the control and thought maybe the board behind the keypad may be faulty. There is signal between the control and keypad as when i start without connection i get "system error". with connection everything boots fine but i have no response from keys.
Id appreciate any help with this.

Thank you.
Paul

Problem solved. Sent Keypad FTE board to an automation company for test/repair.
Control now working however some parameters still incorrect for the machine.

Quote:

---

Originally Posted by flynno83

Hello all,

I recently installed an EPL 2.2 control unit repaired and refurbished by DMG Mori into a CTX 400 lathe. I have a good boot up with all parameters initialised.
When prompted to press operating mode key I have no response from the keypad. I believe i have a good connection back to the control and thought maybe the board behind the keypad may be faulty. There is signal between the control and keypad as when i start without connection i get "system error". with connection everything boots fine but i have no response from keys.
Id appreciate any help with this.

Thank you.

Paul

---

Hi Paul

Are you have ctx400 with ELP2 gieldmaiester parameter
My email [email protected] if possible you please send me.
Best regards
Fatehi