Printable View
Hi,
yesterday I started testing a setup with DeskCNC 2nd. generation controller and HobbyCNC Pro 3-axes controller. Have the HobbyCNC 305OZ/in steppers for all tree axes. Does anyone have the same setup? I need to set the acceleration Ramp for the system...
Hi maycom,
The acceleration settings are done mostly by trial and error, it is also possible to use a spread sheet to calculate the .acc file which will allow you to modify the profile to your hearts content. Just save as a text file and then load it under the Acc. settings menu.
Regards,
Greg
www.cncdirect.co.za