Need Help with Yasnac J300 controller! Alarm codes
I have a Matsuura 510 with a j300 controller.
It was transported and the power has been connected but when the machine was powered on I get the 3 alarm codes.
3002 Emergency Stop
3000 Servo Off
2190 Machine Not ready
Air and oil are in the machine, and the emergency stop has been depressed both on the back of the tool changer and on the front. Have pressed on button on the control 2x
I have hit reset number of times, no luck.
I am not familiar with this controller.
Is there some kind of physical switch or parameter that needs to be turned switched? I do not know the steps that were taken or need to be taken before transportation and after.
Thank you for any feedback.
Re: Need Help with Yasnac J300 controller! Alarm codes
3002 Emergency Stop
3000 Servo Off
2190 Machine Not ready
i have same issue, can some please help. i just had the spindle drive repaired and still have same issue
Re: Need Help with Yasnac J300 controller! Alarm codes
Hello Romanchavez,
I have a Matsuura MC-510V with a problem in the spindle, the inverter has got tha 01 alarm when I try to turn on the spindle, we have checked the IGBT and it´s looks fine, what more can I do?.
Thank´s
Re: Need Help with Yasnac J300 controller! Alarm codes
I had the same issue with the same machine. what cleared the alarm was populating the tool list, for example, I had a 30 tool conveyor tool changer and after I placed an 8888 place holder for up to 30 tools, the alarms cleared and I was able to finally home the machine.