Doosan tt1800sy

I wondering if there is a parameter that can make

The machine ignore wait codes when you are running only one side

Can you put a \ in front of your wait code then turn on block skip?

yes that works but I am afraid that someone will forget to turn it off
when they go back to multi
we have a nakamura wt100 and it just skips over wait code when running one
side

Yes. I believe it's keep relay 0 bit 7 (not parameter), but don't quote me. Look in the blue binder in the electrical cabinet. There's a section in the back half that details the keep relays.

thanks I will check next week when I go back to work.
I will post how I make out

In my book it is listed as K0.0

Thanks that works

Keep relay k0.0 change from 0 to 1
TT 1800 SY
Fanuc 18i -tb

Quote:

---

Originally Posted by Don18P

In my book it is listed as K0.0

---

I knew it was one end of K0 or the other. I don't have a book, and my memory isn't what it once was.

I couldn't find in the book but tried it and it worked thanks all

Technically that's pretty dangerous if your program has crossovers, you could send a tool into a hole the lower was supposed to drill if it ignored wait codes.

I was wrong. I guess the machines typically ignore wait codes running only one side. I hope you found the answer to your question.