Printable View
I have hardinge chnc1 parts for sale . All the electrical parts and some of the air driven parts are getting changed out. Leave a post with email and as I get a chance I will get in touch with you. Just looking to get enough for new aftermarket electrical and drives
looking for CHNC II 16c collet closer parts / also i have a CHNC for parts
Thanks
ed
Dear I need index stop mechanism control, in this mechanism I need one pneumatic control 4 way valve, R481-12 12 volt Dc valve made by CLIPPARD and one valve made by MEAD Chicago HT-100P, Please contact me at [email protected]. Tanks Masroor Anwar
would you have a plate to cover the micro switches on a hardinge chnc 1 i could send you a picture of what i need
Clamdigger,
No but still have other parts ! Also have parts for a CHNC II with 810T control all boards ext.
Thanks Ed
Clam digger,
Found one !!! Came off a CHNC I 810T control . Got plate with switches and cover . [email protected]
Ed
Hi,
Have you still got the Interface board?
Thanks, Allen.
Give me a #
[email protected]
Allen,
Yes ! Want to make sure they match !
Ed
[email protected]
Attachment 435806 hardinge chnc1 i am looking to buy L in the diagram
Looking for a X axis ac motor for a CHNC I
Wiring diagram A13B-0139-8540
Control GEF OTB
CN-3085-T
[email protected]
Do have spare DC motors for CHNC II
CHNC I can't read the tag on the X axis AC fanuc motor to replace ! Can someone help please !
Thanks
Ed
Looking for the sheet metal base for early chncQuote:
Originally Posted by Edwin Murch
Hi
Do you still need the I.d tags for the servo drives?, I removed mine for both
X and Y motors so I could get info for a retrofit,
And can sen pictures if you wish,
Allen
Don’t know if you found one, but unless you want to keep it all stock, I replaced that whole air assembly from Amazon for like $38. Nanpu I think is name. You loose your low-level alarm switch but what the hell. Actually I’m writing because with the stocker I had a problem with water getting past the drier cup and accumulated in the mist feed cup. Problem is, it draws up a tube from the bottom so ya end up feeding water, not oil. Not good.Quote:
Originally Posted by Edwin Murch
Looking for the turret position switch/encoder for a CHNC II under the cover on the cross slide. Mine is encased in a resin body with 6 wires.