Hitachi Seiki with Micon 8 on a Fanuc 6 problems.
Good day and best for the year ahead.
Guys, i got a problem i hope some one out there can help with.
Mori Seiki VA-40 MILL with a FANUC 6 control and assisted by a MICON 8 driven ATC.,
Machine lost its MICON parameters due to battery failure.
Problem is i do not have a back up list for this machine . Found the timers for it but need the parameters for the EPROM settings under the 30/31 mode.
Does any body out there have a list of these parameters or hopefully a similar machine to get a copy of them?
Your help would be appreciated.
Thx Guys
Re: Hitachi Seiki with Micon 8 on a Fanuc 6 problems.
It's a hitachi seiki, not mori.
Is it a micon 8-1 0r 8-2?
Does the micon board have a ptcoda number or sqm8?
I have worked on a lot of hitachi may have what you need.
2 Attachment(s)
Re: Hitachi Seiki with Micon 8 on a Fanuc 6 problems.
Hi jdeere4250
Sorry for the mori thing.
I think it is the Micon 8 Model II (SQM8). it only has 1 switch on the CPU Board(WRSW).
Your help will be appreciated.Attachment 434736Attachment 434738