X4 Setup sheets

Anybody played with this new editor?
I made one with our logo, and some other cool changes, but i cant figure out how to make it make a tool list like the old setup sheets.

I print my new setup sheet and it prints 1 page per tool. A 12 tool job was 14 pages long.

I would like to know more about the master cam setup sheets, any literature would be help full! thanks

I believe there is a large discussion about Set-Up Sheets on the Emastercam Forum.

http://www.emastercam.com/cgi-bin/ul...cgi?category=1

Ok,
I will look into it.

Thanks,

I haven't played with the new setup sheets in X4 yet, but here is an Article that walks you through the X+ setup sheet. It's an excellent setup sheet, free and easy to use.

I just downloaded the setup sheet from the link posted here for Mastercam X4

The language is in German for the setup sheet even when it is in the Mastercam toolbar. I am running Mastercam on a 64bit windows xp system.

How do I change from German to English?

Thank You

I reread the instructions and installed lang.dll in the chook/x4 folder.

I downloaded x+, I ahve used it before in x3.

When I opened it in x4, I can't open the box, it is much to small to see any icons.

any thoughts on how to expand it? it works on the other box's in x4.

thanks for any help,

Tony