Anilam 3300mk

Hello I have a Fryer MB-11 with an Anilam 3300mk control system. The problem is that the computer will not boot up. I get operating system not found error. I believe I have lost all memory in the computer. I cannot load from a floppy disk. I get failure to load from floppy disk drive error. In the startup utilities “cmos bad” was listed. I changed the time and date to see if the cmos battery was good and it did stay in the startup utilities after a shutdown and restart. I checked the battery with a DMM and it read 2.736 volts for a 3V battery. I cannot reset my parameters because all of that is gone. Could this be causing me to not be able to load from floppy drive? Does anyone have any idea about what is wrong with my machine? Any ideas or information? Thank you

Types of errors I'm Getting from the Anilam 3300mk.

failure fixed disk 0

operating system not found

two beeps twenty seconds into start up

CMOS restore condition: [BAD CMOS]

Are these hard drive issues? Can these be fixed? how so?

Thanks

Hello, I have an Anilam 3300Mk controller that has lost all memory and its operating system. I am looking for a boot disk for this controller. If anyone has one that I can use or know where I can get one that would be great. Thanks

I think the problem lies in the CMOS battery going dead as opposed to the hard drive (or flash memory board, depending on which yours has). When the CMOS gets wiped out, it not only resets the date and time to some stored defaults, it also resets or disables the hard drive settings so it can't even begin to locate it's operating system or anilam 1100 software.
I have some CMOS setup sheets for the 1100's that I can e-mail if you'd like. Send me a note at [email protected] and I'll get them off to you.
Regards,
Tim

My mistake. I have the 3300 setup sheets, too.
Tim

I am getting the following when I start up my Anilam 3300mk controller:

0123456
Starting ROM-DOS...
789
Bad or Missing Shell (Command.com)

Does anyone have any ideas what this is or what I can do to fix this?

Give Anilam a call they have some people that will help you. Here is number and name of the person that helped me with a problem like you have. Be sure to leave your name and number he will return your call if he is busy.


Contact info: 726-661-1883 Gerald W. Bouvier Jr. he is a great guy

Toolbit