Fanuc 18T -alarm 1003 t code error

Good morning,

sorry to disturb again but maybe I didn't describe problem in :

We have lathe GA260 with system Fanuc 18 T and turret Sauter with 12 positions

During last week we lost all parameters. We put inside these parameters manually.

Now when we swich-on machine all is going good until we want to turn turret in MDI mode, turret turn (reach requested position also) but
alarm 1003 T-code error appears. (Manually turret turn witout problem)
Description in manual is -Reset number of position

According manual we have to set keeprele K01.1 must be 1 for 12 position and K14 must be written No. of tool position in binary code
If Iam not wrong 12 positions = 00001100

There are T/D parameter also probably have to be set up, or something else. I have to tell I am in the end with my poor knowledge.

Could You help me somebody to solve this problem?
Thanks a lot in advance