Printable View
Help
Hi To all I am new of this forum
I have a Bridgeport series 2 interacts 4 control cnc Heidenaim tnc 150
I have lost the parameters it plots
I have found in internet the parameters of the tnc 155 but in tnc150 everybody don't enter
someone has for case the parameters of the Tnc 150
Thanks to everybody Franco
TRY THESE.
George
Hi MachinTek
Thanks of the fast ultra answer
George
On the pdf you attached there are several empty spaces, 36-39 and 44-49, do i just leave them blank or insert 0 instead?
Cheers
Chris
Hi George
36\39 - 44\49 the empty spaces are Zero
Franco Greets
Certain parameters are machine specific. Such as backlash and travel distances from home to extreme limits. That is why they are blank.
George
thanks for the replys, I have entered the machine parameters as per the pdf above, and following the instructions in the manual the machine goes to manual operation asking to pass over x/y/z/iv reference marks but nothing wants to move, any ideas anyone? I have tried the MOD code 84159 to disable the software limits but still nothing moves!
Chris
Push the orange start button first then keep pushing the green cycle button until it passes over x y z axis regards greg
if you still need the parameter of nc150 i have it notepad you can send it via computer
my e mail [email protected]
send me i will reply you as soon
hasan wafa
hi
Have you arrived you for email?
also find them in fully grown Acrobat reader to the beginning of the page
to the answer of MachineTek
these are the tnc150 parameters with bridgeport 2 interacts 4
the spaces are zero
Ciao A Tutti
You greet to Everybody
I have a question with the personal computer I don't succeed in sending the data in the TNC 150 them I can receive I don't understand as can be.
Cimco transmits them but I doesn't succeed in finding them in Tnc150
does the cable seem that I/you/he/she work perhaps I have some parameter of car from to activate?
Thanks Franco
Backlash can be ZERO. Travel limits need numbers because ZERO would not allow movement.
George