Hi I'm working on a dugard hd1886l with a omfi controller been trying to use g68.2 and it keeps coming with error 5459 and I cannot seem to find anything anywhere about what it is
Thank you for your help in advance
Printable View
Hi I'm working on a dugard hd1886l with a omfi controller been trying to use g68.2 and it keeps coming with error 5459 and I cannot seem to find anything anywhere about what it is
Thank you for your help in advance
-
The parameter No. 19665 to No. 19667, No. 19680 to No.
19744 for configuring the machine are incorrect.
- The axis specified with parameter No. 19681 or No. 19686 is
not a rotary axis.
- In parameter No. 1022, the basic three axes are not set.
- A rotary axis end point found by the NC with tool center point
control type 2, 3-dimensional cutter compensation type 2, or
the tilted working plane command is not within the range set by
parameter No. 19741 to No. 19744.
- No rotary axis end point was found with tool center point
control type 2 or 3-dimensional cutter compensation type 2.
Check the machine configuration and specification.
- On a machine whose rotary axis is a virtual axis, tool center
point control type 2 or 3-dimensional cutter compensation type
2 was specified.
- When programming is performed in the workpiece coordinate
system, tool center point control type 2 or 3-dimensional cutter
compensation type 2 is specified.