TNC151 handwheel

Hi there
My Tnc 151 controller handwheel on milling machine does not work .
Parameter171 is 0 and handwheel is active in point of software view.
I can choose the handwheel mode and select axes.
No alarm occures but no axes movement creates.
Is it a jumper setting problem? If yes which board ? Which jumper? And how to adjust?
Best regards
Majid

Do U keep deadmen switch pushed in?

Quote:

---

Originally Posted by steryd

Do U keep deadmen switch pushed in?

---

Hi Dear
What is deadmen switch and where it is?
Regards
Majid

Quote:

---

Originally Posted by steryd

Do U keep deadmen switch pushed in?

---

Hi Dear
Hanwheel is not remotely it has installed on control panel and no deadmen switch is there.

Then - just guess- it can work in manual not in handwheel mode.