Y-axis move to the left when press right
Hello Everyone,
I have a Chinese CNC cutting machine with a Panasonic servo driver and motor
Servo driver model: MBDJT2210
Servo motor Model : MHMJ042P1S
the Y-axis moves only in the left direction even I move it manually from the control unit when I press the keyboard right key the motor move to the left (and the left key work properly to the left)
I have changed the control unit and the same problem occurred
and all the settings on the controller are correct
please help what is causing this problem
Re: Y-axis move to the left when press right
Check which key is programmed to move axis right the right. This is normally programmable
You could use the MDI screen and issue the following commands
G1 x1 F20 This should move axis to the right one unit
G1 x-1 F20. This should move it to the left two units
If these work it is clearly a key programming issue
Re: Y-axis move to the left when press right
What software you have, check if mapping is correct. Or connect x axis controller to y and see if it behave the same. It will help if know what software you are using.
Re: Y-axis move to the left when press right
Thank you for your reply
The key is normally programmed,
the key is working right to the right sometimes and then suddenly turning to move to the left!!!!
Re: Y-axis move to the left when press right
I have tried to connect the X driver to Y and the same occurred!!!
Re: Y-axis move to the left when press right
Hi,
I suspect that your wiring from the breakout board to the servo drive is somehow faulty. It sounds like the servo drive is NOT getting the correct Direction Signal.
It may be that you have a pull-up resistor when you require a pull-down resistor or similar.
Craig
Re: Y-axis move to the left when press right
Quote:
Originally Posted by
ahmedhamdoun
Hello Everyone,
I have a Chinese CNC cutting machine with a Panasonic servo driver and motor
Servo driver model: MBDJT2210
Servo motor Model : MHMJ042P1S
the Y-axis moves only in the left direction even I move it manually from the control unit when I press the keyboard right key the motor move to the left (and the left key work properly to the left)
I have changed the control unit and the same problem occurred
and all the settings on the controller are correct
please help what is causing this problem
There are two ways to correct this:
1- Change parameter on the CNC controller
2- Change parameter on the servo driver.