Does anyone know how the HAAS MOCON comunicates with the drives?
Ie. PWM, step dir, +-10v ect...
Printable View
Does anyone know how the HAAS MOCON comunicates with the drives?
Ie. PWM, step dir, +-10v ect...
Anyone?
060218-2156 EST USA
miljnor:
Limited info in the manual.
P3 on servo board. PWM and H drive control signals from Motor Interface and overcurrent sense block. 16 KiloHz, Ilimit 20-22 A, nominal supply 160 V. Continuous power output limited. This determination is in "Motor Interface". Send your fax number if you want a copy of the several pages. Not much information.
.