-
POST for HAAS ST10
Hi All,
Has anyone got a working post processor for a Haas ST10? The Haas SL10 post on the dolphin site generates an error saying that this is a V10 and the current Paymaster Dcam is V12, and I should contact dolphin support. About to purchase Lathe, but I am loath to spend nearly $1000 without being able to generate any working test code before I purchase.
Si
-
Re: POST for HAAS ST10
Sorry, it was a bit busy today. You should have a post in your email.
-
Re: POST for HAAS ST10
Got It :-) - Many thanks for the great service.