Enable parameter writing parameter 6219
I have a Hitachi Seiki HT40 lathe with Seicos Multi Interactive control. I am trying to adjust the X axis backlash. I need to enable parameter 6219 by changing from a zero to a 1. It will not change. It appears I have to set a rotary switch on the main circuit board of the control to allow this change to happen.
I do not have a maintenance manual showing the correct setting to do this. Any ideas?
Thanks,
Bud
Re: Enable parameter writing parameter 6219
Bud,
You shouldn’t have to rotate the switch. As long as you have the parameter write under the SET menu enabled and you’re in MDI mode it should work for backlash settings.
Let me know (Assuming this is i80 multi)
John
Sent from my iPhone using Tapatalk
Re: Enable parameter writing parameter 6219
I did not try to search down under the Set tab. I was looking in the PRM tab. I will give it a try.
Thanks
Re: Enable parameter writing parameter 6219
Quote:
Originally Posted by
BAFJB
I did not try to search down under the Set tab. I was looking in the PRM tab. I will give it a try. I tried changing 6219 under the SET tab and it worked great..
Thanks
Bud
Re: Enable parameter writing parameter 6219
I have a Hitachi Seiki HT40 lathe with Seicos Multi Interactive control. I am trying to change control from inches to metric.
I do not have a maintenance manual showing the number of parametr to do this. Any ideas?