Mori CL-20 with Fanuc MF-T8 controller not updating geometry.
Hello,
I have a older Mori CL-20 lathe with the MF-T8 controller.
My issue is I want to run multiple offsets for certain tools, for example T0515 so that I am using offset 15's geometry.
But the issue is that I write it in the program and the controller says it is in offset 15 but it is still using offset 05 geometry.. does anyone know how to fix this issue?
Thank you very much
Re: Mori CL-20 with Fanuc MF-T8 controller not updating geometry.
Set 5002#1 (LGN) = 0
But I am not sure if this control uses the same parameter for this purpose. If not, look into the parameter manual under tool compensation section.
Re: Mori CL-20 with Fanuc MF-T8 controller not updating geometry.
Hello
Can Anyone send manual for this machine I lost All parameter ?Thank you
Re: Mori CL-20 with Fanuc MF-T8 controller not updating geometry.