Tool change and H offset?
Hello, I am new to using Fadals. I recently picked up a 2nd job running this guys Fadal 4020 w/type 88 controller at night. Currently I am manually touching off each tool (tool 0)then setting the Z at the tip of each tool using the SETZ command.
I am sure there is a way to have it remember a tool lengh correct? and use the tool changer?
It is easier for you to read the tech manuals...
Then it would for one of us to explain it simply to you. Don't get me wrong, it is easy to setup and do, but you need these details.
www.fadalcnc.com/fadal_Tech_Docs1.htm is one site that you can pull them up from. Then post again for your questions. My suggestion anyway, and that way what we say, will make more sense.
Steve