Hello,
This my build thread for a 2x3 desk top which I developed over the last few years. Hope you enjoy it!
Attachment 411246
Printable View
Hello,
This my build thread for a 2x3 desk top which I developed over the last few years. Hope you enjoy it!
Attachment 411246
Side frames have shear panels with anchors and carbon fiber reinforced epoxy inside the extrusion slots. They are structurally rigid single pieces.
Attachment 411248
All holes and access points required for assembly are pre-drilled.
Attachment 411250
ASSEMBLY OF MACHINE FRAME:
Attach braces to the 3030 cross beam:
Attachment 411252
Front cross beam installed:
Attachment 411254
Both cross beams installed:
Attachment 411256
Main frame assembled:
Attachment 411258
Feet for the machine are 1" HDPE pucks with pressed-in 1" bolts:
Attachment 411260
They screw directly into the bottom of the extrusions:
Attachment 411262
Feet installed:
Attachment 411264
BED AND TABLE
Bed is a 2x3 aluminum sheet and 1515 stringers. All holes for assembly are pre-machined:
Attachment 411268
Install stringers:
Attachment 411270
Various 1" HDPE parts will be attached to the bed sheet. Spread out an even coat of open gear grease to all the mating surfaces of the HDPE pieces. Make sure all mating surfaces are covered:
Attachment 411272
Attachment 411274
Install the pieces, making sure grease is squeezed out a bit:
Attachment 411276
Attachment 411278
Under side of machine bed with HDPE parts installed:
Attachment 411280
Attachment 411282
Top of machine bed with the 1" HDPE table with clamp slots:
Attachment 411284
Looking good. As with others of this design...how's the side load stiffness?
Thank you fretman_2.
It feels stout so far. I think the epoxy embedment along the full perimeter of the shear plate makes the side panels quite twist resistant. There are three 3030 cross beams connecting the side panels with large corner brackets. One of them is not visible behind the gantry. See attached pic. So far I didn't see a need for them but larger flat brackets could be added to front and back if necessary.
Attachment 411320
With the main frame assembled, 20mm linear rails are installed:
Attachment 411382
Pretty straight forward:
Attachment 411384
Attachment 411386